11-17-2015, 07:08 PM
What type of tooling did you use Russ? Insert with a sharp point or HSS?
Ed
Ed
|
Machining Nylon-Unattended
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Machining Nylon-Unattended - by wrustle - 11-17-2015, 07:04 PM
RE: Machining Nylon-Unattended - by EdK - 11-17-2015, 07:08 PM
RE: Machining Nylon-Unattended - by wrustle - 11-17-2015, 07:23 PM
RE: Machining Nylon-Unattended - by wrustle - 11-17-2015, 07:24 PM
RE: Machining Nylon-Unattended - by EdK - 11-17-2015, 07:29 PM
RE: Machining Nylon-Unattended - by wrustle - 11-17-2015, 08:03 PM
RE: Machining Nylon-Unattended - by EdK - 11-18-2015, 06:40 AM
RE: Machining Nylon-Unattended - by Mayhem - 11-18-2015, 08:34 AM
|
Users browsing this thread: 1 Guest(s)