MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Collets: to rack or not to rack

Thread Modes
Help Collets: to rack or not to rack
zmotorsports Offline
Sophmore
***
Posts: 173
Threads: 2
Joined: Jun 2015
Location: Utah
#4
11-17-2015, 09:18 AM
I am in the same boat with my 5C collets. I don't use them very often so I keep mine in the protective plastic tubes in order of smallest to largest and they are readily accessible when needed. If I used them more I would have them in a rack like the R8 mill collets.

Mike.

Reply
Thanks given by:


Messages In This Thread
Collets: to rack or not to rack - by rleete - 11-16-2015, 05:19 PM
RE: Collets: to rack or not to rack - by EdK - 11-16-2015, 05:59 PM
RE: Collets: to rack or not to rack - by Hawkeye - 11-17-2015, 01:01 AM
RE: Collets: to rack or not to rack - by zmotorsports - 11-17-2015, 09:18 AM
RE: Collets: to rack or not to rack - by Dr Stan - 11-17-2015, 10:41 AM
RE: Collets: to rack or not to rack - by arvidj - 11-17-2015, 08:27 PM
RE: Collets: to rack or not to rack - by Vinny - 11-17-2015, 09:45 PM



Users browsing this thread: 3 Guest(s)