11-07-2015, 10:25 PM
Just set your round stock into one of the table slots. Use multiple clamps to hold it down and just remove / reinstall them as needed to complete cutting your groove as you progress. 
Willie
|
Can I drill v-blocks?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Can I drill v-blocks? - by wawoodman - 11-07-2015, 06:49 PM
RE: Can I drill v-blocks? - by Vinny - 11-07-2015, 07:42 PM
RE: Can I drill v-blocks? - by Highpower - 11-07-2015, 10:25 PM
RE: Can I drill v-blocks? - by rleete - 11-08-2015, 09:05 PM
RE: Can I drill v-blocks? - by PixMan - 11-08-2015, 09:41 PM
|
Users browsing this thread: 1 Guest(s)