QCTP toolholders in aluminum?
#15
Vinnie,

I already have the post. It's a piston type, from CDCO, IIRC. When I bought the set, there was a pretty good price difference between the piston and the wedge. Nowadays, they're almost the same.

Unless/until I can steal a Dorian or Aloris post, I'll probably just stick with what I have.

The first thing I need to harden are the knurl carriers, from Tom's video. I suspect I can do somethng that small with MAPP.
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by:


Messages In This Thread
QCTP toolholders in aluminum? - by wawoodman - 11-05-2015, 09:57 PM
RE: QCTP toolholders in aluminum? - by Vinny - 11-05-2015, 10:17 PM
RE: QCTP toolholders in aluminum? - by chucketn - 11-06-2015, 06:46 AM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 11:57 AM
RE: QCTP toolholders in aluminum? - by PixMan - 11-06-2015, 12:45 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 03:07 PM
RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 04:42 PM
RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 05:24 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 06:25 PM
RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 06:39 PM
RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 07:19 PM
RE: QCTP toolholders in aluminum? - by Vinny - 11-07-2015, 07:29 PM
RE: QCTP toolholders in aluminum? - by Mayhem - 11-07-2015, 08:25 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 08:46 PM



Users browsing this thread: 5 Guest(s)