QCTP toolholders in aluminum?

Thread Modes

QCTP toolholders in aluminum?

Vinny

Another Whipping Boy

Posts: 2,620
Threads: 100
Joined: Dec 2014
Location: Michigan

#13

11-07-2015, 07:29 PM

Mike, I just used 1018. No hardening. Eventually I went the CDCO route. If you go that route, get the wedge type, not the piston. I have one of each and don't like the piston type.

Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique

Website

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

QCTP toolholders in aluminum? - by wawoodman - 11-05-2015, 09:57 PM

RE: QCTP toolholders in aluminum? - by Vinny - 11-05-2015, 10:17 PM

RE: QCTP toolholders in aluminum? - by chucketn - 11-06-2015, 06:46 AM

RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 11:57 AM

RE: QCTP toolholders in aluminum? - by PixMan - 11-06-2015, 12:45 PM

RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 03:07 PM

RE: QCTP toolholders in aluminum? - by Hopefuldave - 11-06-2015, 04:34 PM

RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 04:42 PM