QCTP toolholders in aluminum?
#7
Hardened for wear and to prevent 'em dinging when you drop 'em - a ding on one of the mating surfaces would affect the fit so repeatability would suffer, one of the big plusses of a QCTP is not having to adjust the tool height every time and a burr or ding would shift the position it sat in?
Rules are for the obedience of fools, and the guidance of wise men...
(Douglas Bader)
Reply
Thanks given by:


Messages In This Thread
QCTP toolholders in aluminum? - by wawoodman - 11-05-2015, 09:57 PM
RE: QCTP toolholders in aluminum? - by Vinny - 11-05-2015, 10:17 PM
RE: QCTP toolholders in aluminum? - by chucketn - 11-06-2015, 06:46 AM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 11:57 AM
RE: QCTP toolholders in aluminum? - by PixMan - 11-06-2015, 12:45 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 03:07 PM
RE: QCTP toolholders in aluminum? - by Hopefuldave - 11-06-2015, 04:34 PM
RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 04:42 PM
RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 05:24 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 06:25 PM
RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 06:39 PM
RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 07:19 PM
RE: QCTP toolholders in aluminum? - by Vinny - 11-07-2015, 07:29 PM
RE: QCTP toolholders in aluminum? - by Mayhem - 11-07-2015, 08:25 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 08:46 PM



Users browsing this thread: 3 Guest(s)