MetalworkingFun Forum › Machinery › Milling Machines v
Couple of cutters I picked up

Thread Modes
Couple of cutters I picked up
Roadracer_Al Offline
Junior
****
Posts: 691
Threads: 14
Joined: Feb 2015
Location: Oakland, California
#24
11-06-2015, 02:04 PM
See if Borgeson has an Australian distributor. I don't think you'll like the prices any better, but the do offer double-bearing joints which will accomodate 70* angles.

http://www.borgeson.com/xcart/catalog/Un...1-c-2.html
Reply
Thanks given by:


Messages In This Thread
Couple of cutters I picked up - by Pete O - 10-30-2015, 07:59 AM
RE: Couple of cutters I picked up - by Mayhem - 10-30-2015, 09:21 AM
RE: Couple of cutters I picked up - by DaveH - 10-30-2015, 09:25 AM
RE: Couple of cutters I picked up - by RobWilson - 10-30-2015, 12:12 PM
RE: Couple of cutters I picked up - by EdK - 10-30-2015, 03:22 PM
RE: Couple of cutters I picked up - by Hawkeye - 10-31-2015, 11:33 PM
RE: Couple of cutters I picked up - by Pete O - 10-31-2015, 11:43 PM
RE: Couple of cutters I picked up - by Hawkeye - 11-02-2015, 12:18 AM
RE: Couple of cutters I picked up - by Pete O - 11-02-2015, 02:23 AM
RE: Couple of cutters I picked up - by Hawkeye - 11-03-2015, 12:56 AM
RE: Couple of cutters I picked up - by Pete O - 11-03-2015, 05:45 AM
RE: Couple of cutters I picked up - by Mayhem - 11-03-2015, 06:12 AM
RE: Couple of cutters I picked up - by Pete O - 11-04-2015, 06:30 PM
RE: Couple of cutters I picked up - by f350ca - 11-04-2015, 08:05 PM
RE: Couple of cutters I picked up - by Pete O - 11-05-2015, 10:23 PM
RE: Couple of cutters I picked up - by dallen - 11-05-2015, 11:37 PM
RE: Couple of cutters I picked up - by Pete O - 11-06-2015, 03:09 AM
RE: Couple of cutters I picked up - by RobWilson - 11-06-2015, 04:57 AM
RE: Couple of cutters I picked up - by Pete O - 11-06-2015, 06:53 AM
RE: Couple of cutters I picked up - by Mayhem - 11-06-2015, 06:55 AM
RE: Couple of cutters I picked up - by dallen - 11-06-2015, 08:51 AM
RE: Couple of cutters I picked up - by Roadracer_Al - 11-06-2015, 02:04 PM



Users browsing this thread: 2 Guest(s)