QCTP toolholders in aluminum?
#5
Hardening really wouldn't change the tensile strength of Young's Modulus of the material, so no real need to heat treat.

Given the cost of buying complete ones from CDCO (which need the hardware swapped out for better quality stuff from the git-go) is always an option because he sells them for less than most would spend buying raw material and tooling. I used to buy from Tools4Cheap.net, but he's out of them and closing down his business.
Reply
Thanks given by:


Messages In This Thread
QCTP toolholders in aluminum? - by wawoodman - 11-05-2015, 09:57 PM
RE: QCTP toolholders in aluminum? - by Vinny - 11-05-2015, 10:17 PM
RE: QCTP toolholders in aluminum? - by chucketn - 11-06-2015, 06:46 AM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 11:57 AM
RE: QCTP toolholders in aluminum? - by PixMan - 11-06-2015, 12:45 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 03:07 PM
RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 04:42 PM
RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 05:24 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 06:25 PM
RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 06:39 PM
RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 07:19 PM
RE: QCTP toolholders in aluminum? - by Vinny - 11-07-2015, 07:29 PM
RE: QCTP toolholders in aluminum? - by Mayhem - 11-07-2015, 08:25 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 08:46 PM



Users browsing this thread: 1 Guest(s)