QCTP toolholders in aluminum?
#4
Vinnie,
When you did them in steel, did you harden them? In a non-production situatin, would it matter?
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by:


Messages In This Thread
QCTP toolholders in aluminum? - by wawoodman - 11-05-2015, 09:57 PM
RE: QCTP toolholders in aluminum? - by Vinny - 11-05-2015, 10:17 PM
RE: QCTP toolholders in aluminum? - by chucketn - 11-06-2015, 06:46 AM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 11:57 AM
RE: QCTP toolholders in aluminum? - by PixMan - 11-06-2015, 12:45 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 03:07 PM
RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 04:42 PM
RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 05:24 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 06:25 PM
RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 06:39 PM
RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 07:19 PM
RE: QCTP toolholders in aluminum? - by Vinny - 11-07-2015, 07:29 PM
RE: QCTP toolholders in aluminum? - by Mayhem - 11-07-2015, 08:25 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 08:46 PM



Users browsing this thread: 3 Guest(s)