QCTP toolholders in aluminum?
#3
I have made several QC tool holders out of 6061, as I had some available. Most of them are for light duty, such as DTI holders, and a spring winding jig. I do have a boring bar holder and a turning/facing holder, as I needed them before I had the finds to buy steel ones. The work well and gave me practice on dovetails. I also made a couple tool holders in the pattern of a V-block for cross drilling round stock, but haven't used them much.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
QCTP toolholders in aluminum? - by wawoodman - 11-05-2015, 09:57 PM
RE: QCTP toolholders in aluminum? - by Vinny - 11-05-2015, 10:17 PM
RE: QCTP toolholders in aluminum? - by chucketn - 11-06-2015, 06:46 AM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 11:57 AM
RE: QCTP toolholders in aluminum? - by PixMan - 11-06-2015, 12:45 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 03:07 PM
RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 04:42 PM
RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 05:24 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 06:25 PM
RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 06:39 PM
RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 07:19 PM
RE: QCTP toolholders in aluminum? - by Vinny - 11-07-2015, 07:29 PM
RE: QCTP toolholders in aluminum? - by Mayhem - 11-07-2015, 08:25 PM
RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 08:46 PM



Users browsing this thread: 4 Guest(s)