QCTP toolholders in aluminum?

Hello There, Guest! Register

Thread Modes

QCTP toolholders in aluminum?

Vinny

Online

Another Whipping Boy

Posts: 2,620
Threads: 100
Joined: Dec 2014
Location: Michigan

The following 2 users Like Vinny's post:
EdK (11-06-2015), wrustle (11-07-2015)

#2

11-05-2015, 10:17 PM

I tried 6061 on my mini-lathe once. Switched to 1018. The 6061 just didn't hold up.

Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique

Website

Reply

« Next Oldest | Next Newest »

Messages In This Thread

QCTP toolholders in aluminum? - by wawoodman - 11-05-2015, 09:57 PM

RE: QCTP toolholders in aluminum? - by Vinny - 11-05-2015, 10:17 PM

RE: QCTP toolholders in aluminum? - by chucketn - 11-06-2015, 06:46 AM

RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 11:57 AM

RE: QCTP toolholders in aluminum? - by PixMan - 11-06-2015, 12:45 PM

RE: QCTP toolholders in aluminum? - by wawoodman - 11-06-2015, 03:07 PM

RE: QCTP toolholders in aluminum? - by Hopefuldave - 11-06-2015, 04:34 PM

RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 04:42 PM

RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 05:24 PM

RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 06:25 PM

RE: QCTP toolholders in aluminum? - by wrustle - 11-07-2015, 06:39 PM

RE: QCTP toolholders in aluminum? - by TomG - 11-07-2015, 07:19 PM

RE: QCTP toolholders in aluminum? - by Vinny - 11-07-2015, 07:29 PM

RE: QCTP toolholders in aluminum? - by Mayhem - 11-07-2015, 08:25 PM

RE: QCTP toolholders in aluminum? - by wawoodman - 11-07-2015, 08:46 PM

Users browsing this thread: 5 Guest(s)