MetalworkingFun Forum › Machinery › Milling Machines v
Couple of cutters I picked up

Thread Modes
Couple of cutters I picked up
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#14
11-03-2015, 06:12 AM
Pete - I am pretty sure I have a 1/2" female - female socket UJ somewhere. If I can find it, you are welcome to it. You would just need to mill a 1/2" square at the end of each shaft.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Couple of cutters I picked up - by Pete O - 10-30-2015, 07:59 AM
RE: Couple of cutters I picked up - by Mayhem - 10-30-2015, 09:21 AM
RE: Couple of cutters I picked up - by DaveH - 10-30-2015, 09:25 AM
RE: Couple of cutters I picked up - by RobWilson - 10-30-2015, 12:12 PM
RE: Couple of cutters I picked up - by EdK - 10-30-2015, 03:22 PM
RE: Couple of cutters I picked up - by Hawkeye - 10-31-2015, 11:33 PM
RE: Couple of cutters I picked up - by Pete O - 10-31-2015, 11:43 PM
RE: Couple of cutters I picked up - by Hawkeye - 11-02-2015, 12:18 AM
RE: Couple of cutters I picked up - by Pete O - 11-02-2015, 02:23 AM
RE: Couple of cutters I picked up - by Hawkeye - 11-03-2015, 12:56 AM
RE: Couple of cutters I picked up - by Pete O - 11-03-2015, 05:45 AM
RE: Couple of cutters I picked up - by Mayhem - 11-03-2015, 06:12 AM
RE: Couple of cutters I picked up - by Pete O - 11-04-2015, 06:30 PM
RE: Couple of cutters I picked up - by f350ca - 11-04-2015, 08:05 PM
RE: Couple of cutters I picked up - by Pete O - 11-05-2015, 10:23 PM
RE: Couple of cutters I picked up - by dallen - 11-05-2015, 11:37 PM
RE: Couple of cutters I picked up - by Pete O - 11-06-2015, 03:09 AM
RE: Couple of cutters I picked up - by RobWilson - 11-06-2015, 04:57 AM
RE: Couple of cutters I picked up - by Pete O - 11-06-2015, 06:53 AM
RE: Couple of cutters I picked up - by Mayhem - 11-06-2015, 06:55 AM
RE: Couple of cutters I picked up - by dallen - 11-06-2015, 08:51 AM



Users browsing this thread: 2 Guest(s)