11-03-2015, 12:21 AM
Hi Tom.
One of the uses of the jigs is to locate the cylinder firmly to the rotary table so I can cut the fins with a slitting saw on the mill.
I did not fancy trying to do these with a parting tool on the 7X12, Just a step to far for me.
Brian.
One of the uses of the jigs is to locate the cylinder firmly to the rotary table so I can cut the fins with a slitting saw on the mill.
I did not fancy trying to do these with a parting tool on the 7X12, Just a step to far for me.
Brian.
