Couple of cutters I picked up

Thread Modes

Couple of cutters I picked up

Hawkeye Offline

Junior

Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada

#10

11-02-2015, 12:18 AM

It sounds like you have both arbor supports. Mine only has one, but that hasn't caused any problems.

The power feed shaft on mine may have been a built up one. It looks like a splined shaft with socket-set U-joints welded to the ends. Probably 1/2" drive.

Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Couple of cutters I picked up - by Pete O - 10-30-2015, 07:59 AM

RE: Couple of cutters I picked up - by Mayhem - 10-30-2015, 09:21 AM

RE: Couple of cutters I picked up - by DaveH - 10-30-2015, 09:25 AM

RE: Couple of cutters I picked up - by Sunset Machine - 10-30-2015, 11:31 AM

RE: Couple of cutters I picked up - by RobWilson - 10-30-2015, 12:12 PM

RE: Couple of cutters I picked up - by EdK - 10-30-2015, 03:22 PM

RE: Couple of cutters I picked up - by Roadracer_Al - 10-30-2015, 04:00 PM

RE: Couple of cutters I picked up - by Hawkeye - 10-31-2015, 11:33 PM