10-29-2015, 09:47 AM
I always put 1-2-3 blocks on the table and tram the head to them. That way the indicator tip doesn't have go over the T-slots. I use a co-axial indicator holder to be able to sweep a wide area.
|
mill head to table align'
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
mill head to table align' - by chanse - 02-08-2015, 09:02 PM
RE: mill head to table align' - by Highpower - 02-09-2015, 12:46 AM
RE: mill head to table align' - by fix - 02-09-2015, 11:13 AM
RE: mill head to table align' - by Vinny - 02-09-2015, 03:07 PM
RE: mill head to table align' - by Dr Stan - 02-09-2015, 11:21 PM
RE: mill head to table align' - by chanse - 02-11-2015, 08:55 PM
RE: mill head to table align' - by Shawn - 02-19-2015, 01:56 AM
RE: mill head to table align' - by Roadracer_Al - 02-19-2015, 02:08 AM
RE: mill head to table align' - by Shawn - 02-19-2015, 10:14 AM
RE: mill head to table align' - by Arbalest - 02-19-2015, 05:58 AM
RE: mill head to table align' - by CNCAZ - 10-29-2015, 09:47 AM
RE: mill head to table align' - by dallen - 10-29-2015, 11:59 AM
|
Users browsing this thread: 4 Guest(s)