10-25-2015, 07:40 AM
Does one of those locking levers allow the hub to disengage the handle? My Kondia has a hub with two grooves and a detent ball. The hub on the quill shaft has multiple holes and the hub with the handle has 2 pins. So, you simply pull the handle hub away from the quill shaft hub and the handle is disengaged. I believe that the Bridgeport mills are the same. Wondering if you could fabricate something similar?
Here is the handle and the quill shaft hub (note the old compared to the new!):
Here is the handle and the quill shaft hub (note the old compared to the new!):
Hunting American dentists since 2015.