10-22-2015, 05:06 PM
Yeah the mill is located under the swing of a gantry so getting it on & off the table is not an issue, I'm more concerned about it being too much weight once it is on the table. It's not a horizontal/vertical type, can only be mounted flat to the table.
The cardboard cutout idea sounds good, might do that.
The cardboard cutout idea sounds good, might do that.
Lathe (n); a machine tool used in the production of milling machine components.
Milling Machine (n); a machine tool used in the production of lathe components.
Milling Machine (n); a machine tool used in the production of lathe components.