MetalworkingFun Forum › Machining › General Metalworking Discussion v
(Probably a) stupid question

Thread Modes
(Probably a) stupid question
wawoodman Offline
Junior
****
Posts: 340
Threads: 24
Joined: Aug 2014
Location: Seattle, WA
#9
10-21-2015, 09:48 PM
So if I got one like the HF, could I pick up some weightlifter plates and machine out the centers? I could slide a couple down over the post. AFAIK, they're just cast iron.
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by:


Messages In This Thread
(Probably a) stupid question - by wawoodman - 10-20-2015, 12:08 PM
RE: (Probably a) stupid question - by krv3000 - 10-20-2015, 01:12 PM
RE: (Probably a) stupid question - by wawoodman - 10-20-2015, 02:07 PM
RE: (Probably a) stupid question - by TomG - 10-20-2015, 04:20 PM
RE: (Probably a) stupid question - by Pete O - 10-20-2015, 04:36 PM
RE: (Probably a) stupid question - by Micktoon - 10-20-2015, 04:56 PM
RE: (Probably a) stupid question - by Pete O - 10-20-2015, 08:35 PM
RE: (Probably a) stupid question - by Mayhem - 10-20-2015, 07:24 PM
RE: (Probably a) stupid question - by wawoodman - 10-21-2015, 09:48 PM
RE: (Probably a) stupid question - by Vinny - 10-21-2015, 09:59 PM
RE: (Probably a) stupid question - by wawoodman - 10-21-2015, 11:32 PM
RE: (Probably a) stupid question - by EdK - 10-28-2015, 05:07 PM



Users browsing this thread: 4 Guest(s)