10-19-2015, 10:20 AM
Great looking tools there Kenny!
Now when you state "within .0005" in heights", that sounds odd because if you take the "final pass" for height the pair should be together on the surface grinder's magnetic chuck and ground at the same time, same height. Is that what you did? If so they should be identical height and no way off by up to .0005".
Now when you state "within .0005" in heights", that sounds odd because if you take the "final pass" for height the pair should be together on the surface grinder's magnetic chuck and ground at the same time, same height. Is that what you did? If so they should be identical height and no way off by up to .0005".