10-17-2015, 08:40 PM
Decided to go with a steel dial, chemically blue it then polish off the surface hopefully leaving the lines blued.
Got the blank made, thats the original dial on top.
Tried to figure out the indexing head to cut the required 125 divisions. Works out that I need a 25 division plate, of course I don't have one, looked into compound indexing in the machinist handbook, decided it would be a whole lot easier to make a 50 decision plate using the 15 division one.
Got the blank made, thats the original dial on top.
Tried to figure out the indexing head to cut the required 125 divisions. Works out that I need a 25 division plate, of course I don't have one, looked into compound indexing in the machinist handbook, decided it would be a whole lot easier to make a 50 decision plate using the 15 division one.
Free advice is worth exactly what you payed for it.
Greg
Greg