10-17-2015, 02:40 PM
finally had some time after needing to do maintenance work . Had a few projects all goin on at once so fig id finish this one so I can work on needed mods for the machines. Hers is a set of parallels for my 5 Homge vise to use on my new PM932 . . Nothing special needed a wider set . Started out with a pc of unknown stock , fly cut cut blanks face milled started out ½ thk was going to make .437 didnt likem ended up millin down again settled with 3/8 thickness. They are only within .0005 in the heights in which I did surface grind. Was going to make a nice wooden box but than saw I had this box that would be perfect to house them. Little cut foam/ rubber hot clue done deal. Well thats about it on to the next project for the mill