Latest Delivery

[RobWilson]

(10-14-2015, 06:51 AM)awemawson Wrote: Rob, don't forget that that's a variable auto transformer, so not isolating. A bit dodgy to use it directly for your plating set up

Fully aware of what it is and is not Andrew, thanks for your concern  , I was planning on wearing thick rubber gloves and wellies     , seriously I   do have a 1:1 isolating transformer   , this is mainly going to be used for testing motors and coils and a few experiments anodizing at a higher voltage .  

I have other gear set aside for a more permanent plating setup ,another project in itself 

Anway picked up a quicktest block today to add to the variac project .





This will be mounted on the case when made , much safer than binding posts .



Rob