10-10-2015, 05:16 PM
once drilled I then made a peg to go in the centre of the blade the hole being 5.5mm then drilled for m3 thread then filed the notch out of the front of the blank for the blade to sit flush with the face of the blank once dun I then silver soldered the centre pin in place then cleaned it all
up sos no pics of the next bit I made the screw head bigger so the out side diameter is gnaw 7.5mm this was silver soldered on to the head of the screw so it will levee a step on the inside then I just rounded the top off all dun right pics
up sos no pics of the next bit I made the screw head bigger so the out side diameter is gnaw 7.5mm this was silver soldered on to the head of the screw so it will levee a step on the inside then I just rounded the top off all dun right pics
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.