The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Roller for bending flat bar

Thread Modes
Roller for bending flat bar
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#1
10-07-2015, 01:21 PM
Somewhere I recall seeing a write up on making a flywheel rim or maybe a traction engine wheel from flat stock by rolling it into a circle. Can anyone point me to such a build? What is that type of roller called? Any plans for such floating around?
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Roller for bending flat bar - by chucketn - 10-07-2015, 01:21 PM
RE: Roller for bending flat bar - by f350ca - 10-07-2015, 08:17 PM
RE: Roller for bending flat bar - by Roadracer_Al - 10-07-2015, 08:48 PM



Users browsing this thread: 1 Guest(s)