Input for End Mill

Thread Modes

Input for End Mill

Thumb

Sophmore

Posts: 63
Threads: 10
Joined: Jun 2015
Location: Medford, Or

#15

10-06-2015, 08:56 PM (This post was last modified: 10-06-2015, 09:03 PM by Thumb.)

(10-06-2015, 06:38 PM)Vinny Wrote: They have no closeouts or discontinued product?

Not online they didn't but I can go to the store itself and check it out. They also have a lot of gun related tooling.

TomG, I'll check them out and see what I can come up with.

Oh, what type should I be looking for, square end, rounded edge, uncoated, coated or something else?

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Input for End Mill - by Thumb - 10-04-2015, 10:15 PM

RE: Input for End Mill - by Highpower - 10-05-2015, 08:24 AM

RE: Input for End Mill - by Thumb - 10-05-2015, 08:34 AM

RE: Input for End Mill - by dallen - 10-05-2015, 01:56 PM

RE: Input for End Mill - by EdK - 10-05-2015, 04:10 PM

RE: Input for End Mill - by Thumb - 10-05-2015, 09:40 PM

RE: Input for End Mill - by Vinny - 10-05-2015, 10:03 PM

RE: Input for End Mill - by Thumb - 10-05-2015, 11:55 PM

RE: Input for End Mill - by Mayhem - 10-06-2015, 05:52 AM