10-06-2015, 05:52 AM
Hi Thumb - glad to hear you got the sight off. Personally, I purchased a small selection of 4 flute and two flute Toolmex endmills, which are made in Poland. So far they seem to hold up OK. Like you, I was a little overwhelmed by the selection, so I decided to start with the very basics and then see what I needed to add.
Actually, I shouldn't complain as Russ (wrustle) very generously gifted me a box of assorted HSS and solid carbide endmills. He also took the time to test each one of them to make sure they worked
I would hate to think what it would have cost me to buy them here
(10-05-2015, 10:03 PM)Vinny Wrote: If you have a tool supply place near you (I have wholesale tool about an hour away) check out their closeout section. I often get end mills for about a buck a piece.
Actually, I shouldn't complain as Russ (wrustle) very generously gifted me a box of assorted HSS and solid carbide endmills. He also took the time to test each one of them to make sure they worked
I would hate to think what it would have cost me to buy them here
Hunting American dentists since 2015.