10-05-2015, 06:05 PM
Not sure how your cross slide nut is attached, but I had a similar problem with my Logan. Turned out the nut was not perfectly lined up. I loosened the nut, cranked the cross slide all the way in and re-tightened. All was well after that.
Now after re-reading your description it seems you're saying the cross slide was moving nicely until you adjusted it again. Over the years if you're only using a small section of the travel it'll get worn more than where it doesn't get traveled that often. You'll need to clean up the cross slide dovetail if that's the case.
Now after re-reading your description it seems you're saying the cross slide was moving nicely until you adjusted it again. Over the years if you're only using a small section of the travel it'll get worn more than where it doesn't get traveled that often. You'll need to clean up the cross slide dovetail if that's the case.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique
the nobucks boutique etsy shop | the nobucks boutique