10-05-2015, 05:31 PM
Just so you don't think I'm sloughing off, here are a few pictures. I'm ending up having to rearrange the shop space for the new mill. I had originally laid it out for my bench-top mill but that arrangement isn't going to work for the new mill. I've been cleaning and purging lots of stuff from the basement to make room. I should have purged a lot of the stuff a long time ago. Oh well, it's getting done now. 
I'm about ready to run the wiring for powering the mill. I still have some cleaning/rearranging/purging to do but my goal is to have all of that done by next weekend so I can start to concentrate on the dis-assembly of the mill. We'll see if I reach my goal since work has me exhausted most days.
Ed
The layout including the bench-top mill.
The new layout.
Where the lathe is currently located. You can see I still have some rearranging to do.
Where it will move to. Those shelves have to come down.
The shop area.
I'm about ready to run the wiring for powering the mill. I still have some cleaning/rearranging/purging to do but my goal is to have all of that done by next weekend so I can start to concentrate on the dis-assembly of the mill. We'll see if I reach my goal since work has me exhausted most days.
Ed
The layout including the bench-top mill.
The new layout.
Where the lathe is currently located. You can see I still have some rearranging to do.
Where it will move to. Those shelves have to come down.
The shop area.