Input for End Mill

Thread Modes

Input for End Mill

Thumb

Sophmore

Posts: 63
Threads: 10
Joined: Jun 2015
Location: Medford, Or

10-05-2015, 08:34 AM

Yes Highpower, it's the base I am taking off. I also removed the little set screw that I didn't even see until I had it on the mill.

Will stay away form the cheap ones. Right now I don't think I'll be doing any work that demands perfection but you never know. Thanks

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Input for End Mill - by Thumb - 10-04-2015, 10:15 PM

RE: Input for End Mill - by Highpower - 10-05-2015, 08:24 AM

RE: Input for End Mill - by Thumb - 10-05-2015, 08:34 AM

RE: Input for End Mill - by dallen - 10-05-2015, 01:56 PM

RE: Input for End Mill - by EdK - 10-05-2015, 04:10 PM

RE: Input for End Mill - by Thumb - 10-05-2015, 09:40 PM

RE: Input for End Mill - by Vinny - 10-05-2015, 10:03 PM

RE: Input for End Mill - by Thumb - 10-05-2015, 11:55 PM

RE: Input for End Mill - by Mayhem - 10-06-2015, 05:52 AM