The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Turning Down a Motor Shaft

Thread Modes
Turning Down a Motor Shaft
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#1
06-03-2012, 05:53 PM
I have a 3-phase motor that has a shaft size of 24mm and would like to turn it down to 19mm. Has anyone done that and if so is it hard to do? I don't want to ruin the motor, obviously.

Thanks,
Ed


.jpg   2799.jpg (Size: 19.01 KB / Downloads: 167)
Reply
Thanks given by:


Messages In This Thread
Turning Down a Motor Shaft - by EdK - 06-03-2012, 05:53 PM
RE: Turning Down a Motor Shaft - by November X-ray - 06-03-2012, 06:51 PM
RE: Turning Down a Motor Shaft - by stevec - 06-03-2012, 07:20 PM
RE: Turning Down a Motor Shaft - by f350ca - 06-03-2012, 08:44 PM
RE: Turning Down a Motor Shaft - by Mayhem - 06-03-2012, 09:41 PM
RE: Turning Down a Motor Shaft - by Tony Wells - 06-03-2012, 09:41 PM
RE: Turning Down a Motor Shaft - by EdK - 06-04-2012, 07:41 AM
RE: Turning Down a Motor Shaft - by jhovel - 06-07-2012, 06:27 AM
RE: Turning Down a Motor Shaft - by stevec - 06-07-2012, 06:31 PM
RE: Turning Down a Motor Shaft - by dallen - 06-07-2012, 10:00 PM
RE: Turning Down a Motor Shaft - by Tony Wells - 06-08-2012, 09:02 PM
RE: Turning Down a Motor Shaft - by EdK - 06-09-2012, 03:59 PM
RE: Turning Down a Motor Shaft - by Highpower - 06-10-2012, 08:06 AM
RE: Turning Down a Motor Shaft - by EdK - 06-11-2012, 03:47 PM
RE: Turning Down a Motor Shaft - by EdK - 06-09-2012, 04:00 PM
RE: Turning Down a Motor Shaft - by stevec - 06-09-2012, 07:11 PM
RE: Turning Down a Motor Shaft - by stevec - 06-11-2012, 03:09 PM
RE: Turning Down a Motor Shaft - by EdK - 06-11-2012, 03:50 PM
RE: Turning Down a Motor Shaft - by stevec - 06-12-2012, 06:39 AM
RE: Turning Down a Motor Shaft - by doubleboost - 06-12-2012, 03:45 PM



Users browsing this thread: 1 Guest(s)