09-18-2015, 06:37 AM
Hi Darren (Mayhem), I think you are right that a R8 to 16mm arbor is the obvious choice. It should give the minimum runout and I will probably buy one to get started.
However I really like the Tormach system and would still like to try options 3 or 4. Just not sure which would give the better result. May have to try both and see what turns out best. Its only money and a bit of machining time.
If I mount a tormach blank arbor in a ER32 collet on the lathe do you think the run out will be be tolerable?
Thanks
Ron
However I really like the Tormach system and would still like to try options 3 or 4. Just not sure which would give the better result. May have to try both and see what turns out best. Its only money and a bit of machining time.
If I mount a tormach blank arbor in a ER32 collet on the lathe do you think the run out will be be tolerable?
Thanks
Ron
ronboult, proud to be a member of MetalworkingFun Forum since Aug 2013.