Cutting a blind keyway
#17
Over here the term slot drill is not used. It seems they're all just end mills. Some are center cutting, some aren't. There are two flute, three flute, four flute and more flute, some with corner radius and some sharp. And all are listed as end mills.

We seem to get along fine without knowing what a slot drill is.

Smile
Reply
Thanks given by:


Messages In This Thread
Cutting a blind keyway - by Pete O - 09-11-2015, 04:02 AM
RE: Cutting a blind keyway - by RobWilson - 09-11-2015, 04:25 AM
RE: Cutting a blind keyway - by Pete O - 09-11-2015, 07:04 AM
RE: Cutting a blind keyway - by RobWilson - 09-11-2015, 09:03 AM
RE: Cutting a blind keyway - by RobWilson - 09-12-2015, 10:05 AM
RE: Cutting a blind keyway - by DaveH - 09-11-2015, 07:59 AM
RE: Cutting a blind keyway - by TomG - 09-11-2015, 07:31 PM
RE: Cutting a blind keyway - by PixMan - 09-11-2015, 07:57 PM
RE: Cutting a blind keyway - by EdK - 09-11-2015, 08:07 PM
RE: Cutting a blind keyway - by f350ca - 09-11-2015, 08:18 PM
RE: Cutting a blind keyway - by PixMan - 09-12-2015, 06:23 AM
RE: Cutting a blind keyway - by TomG - 09-12-2015, 09:52 AM
RE: Cutting a blind keyway - by mcostello - 09-12-2015, 12:10 PM
RE: Cutting a blind keyway - by Pete O - 09-16-2015, 08:00 PM
RE: Cutting a blind keyway - by Pete O - 09-18-2015, 04:35 AM
RE: Cutting a blind keyway - by Mayhem - 09-18-2015, 05:07 AM
RE: Cutting a blind keyway - by PixMan - 09-18-2015, 06:34 AM
RE: Cutting a blind keyway - by Mayhem - 09-18-2015, 06:44 AM
RE: Cutting a blind keyway - by Highpower - 09-18-2015, 07:42 AM
RE: Cutting a blind keyway - by EdK - 09-18-2015, 07:51 AM
RE: Cutting a blind keyway - by Highpower - 09-18-2015, 08:08 AM
RE: Cutting a blind keyway - by Pete O - 09-18-2015, 07:55 AM
RE: Cutting a blind keyway - by Highpower - 09-18-2015, 08:19 AM
RE: Cutting a blind keyway - by PixMan - 09-18-2015, 10:22 AM
RE: Cutting a blind keyway - by DaveH - 09-18-2015, 01:10 PM
RE: Cutting a blind keyway - by Vinny - 09-18-2015, 05:17 PM
RE: Cutting a blind keyway - by TomG - 09-19-2015, 08:46 AM
RE: Cutting a blind keyway - by Highpower - 09-19-2015, 10:31 AM
RE: Cutting a blind keyway - by Vinny - 09-19-2015, 04:03 PM



Users browsing this thread: 6 Guest(s)