MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Cutting a flute on a tap

Thread Modes
Help Cutting a flute on a tap
trevatxtal Offline
Freshman
**
Posts: 24
Threads: 1
Joined: Jul 2014
Location: Devon, UK
#6
09-15-2015, 02:43 AM
Hello
I seem to recall that a offset to centre ball mill cut will give a cutting edge on one side.
An end on view of a large tap will indicate which way.
Trev
trevatxtal, proud to be a member of MetalworkingFun Forum since Jul 2014.
Reply
Thanks given by:


Messages In This Thread
Cutting a flute on a tap - by ieezitin - 09-12-2015, 08:00 PM
RE: Cutting a flute on a tap - by Hopefuldave - 09-13-2015, 07:33 AM
RE: Cutting a flute on a tap - by DaveH - 09-13-2015, 08:00 AM
RE: Cutting a flute on a tap - by TomG - 09-14-2015, 06:45 AM
RE: Cutting a flute on a tap - by ieezitin - 09-14-2015, 04:52 PM
RE: Cutting a flute on a tap - by trevatxtal - 09-15-2015, 02:43 AM
RE: Cutting a flute on a tap - by ieezitin - 09-20-2015, 10:52 AM
RE: Cutting a flute on a tap - by DaveH - 09-20-2015, 11:26 AM
RE: Cutting a flute on a tap - by Highpower - 09-20-2015, 11:38 AM
RE: Cutting a flute on a tap - by RobWilson - 09-20-2015, 12:15 PM
RE: Cutting a flute on a tap - by Mayhem - 09-20-2015, 05:33 PM
RE: Cutting a flute on a tap - by TomG - 09-20-2015, 07:58 PM
RE: Cutting a flute on a tap - by Hopefuldave - 09-25-2015, 06:22 PM



Users browsing this thread: 4 Guest(s)