09-13-2015, 01:35 AM
Hi there Kenny
The link bars , as soon as you select CCW the link bar is a dead short .
Your mill has a FWD/REV switch , so you don't need the terminal block link bars , the link bars set the motor rotation direction ,remove them . The switch does the job of the links . Thats the reason for the 4 wires (2 red 2 black ) going to the motor .
Rob
Quote:I suspect one thing is off Cuz motor works fine in CW However CCW interrupts ( shorts) the circuit
The link bars , as soon as you select CCW the link bar is a dead short .
Your mill has a FWD/REV switch , so you don't need the terminal block link bars , the link bars set the motor rotation direction ,remove them . The switch does the job of the links . Thats the reason for the 4 wires (2 red 2 black ) going to the motor .
Rob