[HELP] Help w/ Pm932 motor wiring or PM 220V

[Kennyv]

(09-12-2015, 02:38 PM)Vinny Wrote: Maybe this will help:

http://www.kenworthproducts.co.uk/acatal...0phase.pdf

thanks Vinny But has dif terminal block config this post does as far a same term block with start/ run cap
http://www.hobby-machinist.com/threads/n...task.2696/

same term block but DOES not give SHOW the internal wiring for motor
in fact the inside cover comes with a diag that does not match or make sense ..I suspect one thing is off Cuz motor works fine in CW However CCW interrupts ( shorts) the circuit