Cutting a blind keyway
#4
Pete,
Just to say the way Rob has suggested is the correct way to mill a slot. It is also important to use a slot mill / slot drill and not an end mill. You probably are using a slot mill but you refer to it as an end mill.

This may help a little http://www.metalworkingfun.com/thread-776.html

Smiley-eatdrink004 
DaveH
Reply
Thanks given by:


Messages In This Thread
Cutting a blind keyway - by Pete O - 09-11-2015, 04:02 AM
RE: Cutting a blind keyway - by RobWilson - 09-11-2015, 04:25 AM
RE: Cutting a blind keyway - by Pete O - 09-11-2015, 07:04 AM
RE: Cutting a blind keyway - by RobWilson - 09-11-2015, 09:03 AM
RE: Cutting a blind keyway - by RobWilson - 09-12-2015, 10:05 AM
RE: Cutting a blind keyway - by DaveH - 09-11-2015, 07:59 AM
RE: Cutting a blind keyway - by TomG - 09-11-2015, 07:31 PM
RE: Cutting a blind keyway - by PixMan - 09-11-2015, 07:57 PM
RE: Cutting a blind keyway - by EdK - 09-11-2015, 08:07 PM
RE: Cutting a blind keyway - by f350ca - 09-11-2015, 08:18 PM
RE: Cutting a blind keyway - by PixMan - 09-12-2015, 06:23 AM
RE: Cutting a blind keyway - by TomG - 09-12-2015, 09:52 AM
RE: Cutting a blind keyway - by mcostello - 09-12-2015, 12:10 PM
RE: Cutting a blind keyway - by Pete O - 09-16-2015, 08:00 PM
RE: Cutting a blind keyway - by Pete O - 09-18-2015, 04:35 AM
RE: Cutting a blind keyway - by Mayhem - 09-18-2015, 05:07 AM
RE: Cutting a blind keyway - by PixMan - 09-18-2015, 06:34 AM
RE: Cutting a blind keyway - by Mayhem - 09-18-2015, 06:44 AM
RE: Cutting a blind keyway - by Highpower - 09-18-2015, 07:42 AM
RE: Cutting a blind keyway - by EdK - 09-18-2015, 07:51 AM
RE: Cutting a blind keyway - by Highpower - 09-18-2015, 08:08 AM
RE: Cutting a blind keyway - by Pete O - 09-18-2015, 07:55 AM
RE: Cutting a blind keyway - by Highpower - 09-18-2015, 08:19 AM
RE: Cutting a blind keyway - by PixMan - 09-18-2015, 10:22 AM
RE: Cutting a blind keyway - by DaveH - 09-18-2015, 01:10 PM
RE: Cutting a blind keyway - by Vinny - 09-18-2015, 05:17 PM
RE: Cutting a blind keyway - by TomG - 09-19-2015, 08:46 AM
RE: Cutting a blind keyway - by Highpower - 09-19-2015, 10:31 AM
RE: Cutting a blind keyway - by Vinny - 09-19-2015, 04:03 PM



Users browsing this thread: 2 Guest(s)