Setting Up My PM935 Mill

[EdK]

No joy but no smoke either. I powered up the VFD without letting the magic smoke out so a good start. There's a power up test that you go through to set a few parameters to match your motor before you drive the motor with the VFD. There are many groups of parameters and even more settings within each group. I wasn't able to get to a few of the groups at all to set some of the motor specs so I finally called it a night and decided to get the aid of Mr Google. He came through as usual. The very first YouTube video I watched revealed that there's a parameter you need to set to enable all possible settings. It comes with a default setting of "Basic display" and needs to be changed to "Full display". You'd think in the section that takes you through the steps to set it up for the power up test, they'd tell you that you need to enable the "Full display" setting in order to make the changes they are walking you through.  

I'll try again tomorrow if I have time. My brother is coming over and we're going to work on our niece's kitchen counter top. Yuk!

Ed