Setting Up My PM935 Mill

[EdK]

(09-03-2015, 09:10 PM)TomG Wrote: A good looking mill Ed, from what I can see. I was going to say that it'll never be that clean again, but then I remembered who I was talking to.

I'm sure you will have a lot of fun setting it up.

Tom

Thanks Tom. Sorry about the lack of detail in the pictures. It's so hot and humid here now that I don't want to remove the plastic until the humidity drops. Today is supposed to be even worse than yesterday and tomorrow about the same. Sunday is when the cool front comes through and the humidity is supposed to plummet later in the day with highs in the 70s starting Monday. So the plan is to unwrap it on Sunday afternoon or evening and get it ready for a test run on Monday.

Ed