Todays Project - What did you do today?

[johnnyc14]

(09-01-2015, 01:24 PM)zmotorsports Wrote: That looks good Johnny.  What did you use for the engine turned look?

Mike.

Thanks Mike, I just used a 2 inch 3M Scotchbrite Roloc disc in the drill chuck. I ran the machine at 200 rpm and just brought the disc into light contact for 3 or 4 seconds in each position. I spaced the contacts on 1 inch centres starting in the centre of the panel. It was easier than trying to polish the stainless to an even finish.