08-30-2015, 03:33 PM
I know this post is about cranes but I have the same problem when installing new bench top CNC mills and even though I have a crane I hardly ever use it and much prefer to use two of the hydraulic lifting tables. I say two because often I have to negotiate steps and I put one table one side and the other table at the opposite level then bring the tables up to equal hight and slide the machine across with a steel plate between the two.
Add to this those cranes can't move thru single doorways, they are far too wide.
TBH now I have these tables I wonder how I worked without them. They are a means to lift and move things, a work bench that is always at the correct hight and have to convieniance of being able to be moved easy.
Add to this those cranes can't move thru single doorways, they are far too wide.
TBH now I have these tables I wonder how I worked without them. They are a means to lift and move things, a work bench that is always at the correct hight and have to convieniance of being able to be moved easy.
John S., Nottingham, England.