08-30-2015, 08:29 AM
(08-30-2015, 04:25 AM)doubleboost Wrote: HiHi John,
I have borrowed a 63 tooth change wheel to use as a conversion (metric to imperial)
This works very well
I want to make my own but can only get 64 teeth with my deviding head
As the 63 is half of a 127 (should be 63 1/2 )
How much difference would a 64 make
John
I'm not a Mathematician but I know my 2 times table - does that count
A 63 or 64 will not make a blind bit of difference to threads that are used for holding and the holding part of the thread is short (say less than 12mm) ie the nut is 12mm long.
It wouldn't make a very accurate lead screw - in the region of about 1% error.
DaveH