08-28-2015, 03:18 PM
Thanks DaveD, I will be careful 
I have used it a couple of times taking the 6 ton log splitter on and off the welding table, which weighs perhaps 80lbs. A 2 ton engine crane was a bit of an over kill, it just looked so much better made than the 1 ton one. 120lbs is probably the heaviest load I will lift on and of the table - the 3 ton arbor press.
As for taking an engine out the car
I'll just go and buy a new car
DaveH
I have used it a couple of times taking the 6 ton log splitter on and off the welding table, which weighs perhaps 80lbs. A 2 ton engine crane was a bit of an over kill, it just looked so much better made than the 1 ton one. 120lbs is probably the heaviest load I will lift on and of the table - the 3 ton arbor press.
As for taking an engine out the car
I'll just go and buy a new car DaveH