Time to build a moulding bench

Hello There, Guest! Register

Thread Modes

Time to build a moulding bench

RobWilson
Unregistered

The following 2 users Like RobWilson's post:
chucketn (08-25-2015), oldgoaly (08-25-2015)

#12

08-25-2015, 02:31 PM

Hi Pete ,

My moulding bench is all steel apart from the top . about 4ft x 2 1/2 ft

[Image: P1090004_zpsxoamaeqb.jpg]

[Image: P1090005_zpsbgknueqh.jpg]

Made an extension to hold a wood working vice ,so it doubles as a pattern making bench .

[Image: P1070943_zpstr0zf67a.jpg]

Rob

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Time to build a moulding bench - by Pete O - 08-23-2015, 07:20 AM

RE: Time to build a moulding bench - by dallen - 08-23-2015, 08:53 AM

RE: Time to build a moulding bench - by f350ca - 08-23-2015, 12:41 PM

RE: Time to build a moulding bench - by the artfull-codger - 08-23-2015, 01:14 PM

RE: Time to build a moulding bench - by texx - 08-23-2015, 04:02 PM

RE: Time to build a moulding bench - by dallen - 08-23-2015, 06:49 PM

RE: Time to build a moulding bench - by Pete O - 08-23-2015, 07:47 PM

RE: Time to build a moulding bench - by the artfull-codger - 08-24-2015, 04:12 PM

RE: Time to build a moulding bench - by Pete O - 08-23-2015, 09:16 PM

RE: Time to build a moulding bench - by dallen - 08-23-2015, 10:28 PM

RE: Time to build a moulding bench - by oldgoaly - 08-25-2015, 04:45 AM

RE: Time to build a moulding bench - by RobWilson - 08-25-2015, 02:31 PM

RE: Time to build a moulding bench - by Pete O - 08-28-2015, 01:56 AM

RE: Time to build a moulding bench - by Pete O - 02-28-2016, 03:40 AM

RE: Time to build a moulding bench - by Mayhem - 02-28-2016, 05:30 AM

RE: Time to build a moulding bench - by Pete O - 02-28-2016, 06:03 AM

RE: Time to build a moulding bench - by Pete O - 03-15-2016, 02:01 AM

RE: Time to build a moulding bench - by Mayhem - 03-15-2016, 06:18 AM

RE: Time to build a moulding bench - by Pete O - 03-15-2016, 06:48 AM

RE: Time to build a moulding bench - by oldskoolron - 08-09-2016, 10:11 PM

Users browsing this thread: 3 Guest(s)