MetalworkingFun Forum › Machining › General Metalworking Discussion v
Knurl looseness okay?

Thread Modes
Knurl looseness okay?
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
#9
08-23-2015, 08:51 AM
I would be concerned about the quality of the made knurl if one knurl wheel was moving .005" and the other wasn't. As long as they are both the same thickness and have the same amount of clearance in the holder, it shouldn't make any difference in the workpiece.
Reply
Thanks given by:


Messages In This Thread
Knurl looseness okay? - by MikeK - 08-21-2015, 12:30 PM
RE: Knurl looseness okay? - by PixMan - 08-22-2015, 11:44 AM
RE: Knurl looseness okay? - by MikeK - 08-22-2015, 12:55 PM
RE: Knurl looseness okay? - by Hawkeye - 08-23-2015, 12:06 AM
RE: Knurl looseness okay? - by RobWilson - 08-23-2015, 03:06 AM
RE: Knurl looseness okay? - by Mayhem - 08-23-2015, 06:00 AM
RE: Knurl looseness okay? - by stevec - 08-23-2015, 07:05 AM
RE: Knurl looseness okay? - by arvidj - 08-23-2015, 08:02 AM
RE: Knurl looseness okay? - by PixMan - 08-23-2015, 08:51 AM



Users browsing this thread: 4 Guest(s)