|
Knurl looseness okay?
|
08-23-2015, 12:06 AM
If you slip in a thin washer to make the thin wheel fit like the other one, you might be able to run it in both directions, if needed. Some 5 thou shim stock should do the trick.
Mike
If you can't get one, make one. Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Knurl looseness okay? - by MikeK - 08-21-2015, 12:30 PM
RE: Knurl looseness okay? - by PixMan - 08-22-2015, 11:44 AM
RE: Knurl looseness okay? - by MikeK - 08-22-2015, 12:55 PM
RE: Knurl looseness okay? - by Hawkeye - 08-23-2015, 12:06 AM
RE: Knurl looseness okay? - by RobWilson - 08-23-2015, 03:06 AM
RE: Knurl looseness okay? - by Mayhem - 08-23-2015, 06:00 AM
RE: Knurl looseness okay? - by stevec - 08-23-2015, 07:05 AM
RE: Knurl looseness okay? - by arvidj - 08-23-2015, 08:02 AM
RE: Knurl looseness okay? - by PixMan - 08-23-2015, 08:51 AM
|
