Knurl looseness okay?
#2
That variation could cause tracking problems when making diamond knurls. It wouldn't be a problem with straight knurls though.

I probably wouldn't make a holder to the width of the smallest, but instead just make it the standard .375" wide and try it. If you feed a knurl only in one direction, there should be no problems and your tool is good for when you do buy new, high quality knurl wheels from the likes of Form Rol Die or Accutrak.
Reply
Thanks given by:


Messages In This Thread
Knurl looseness okay? - by MikeK - 08-21-2015, 12:30 PM
RE: Knurl looseness okay? - by PixMan - 08-22-2015, 11:44 AM
RE: Knurl looseness okay? - by MikeK - 08-22-2015, 12:55 PM
RE: Knurl looseness okay? - by Hawkeye - 08-23-2015, 12:06 AM
RE: Knurl looseness okay? - by RobWilson - 08-23-2015, 03:06 AM
RE: Knurl looseness okay? - by Mayhem - 08-23-2015, 06:00 AM
RE: Knurl looseness okay? - by stevec - 08-23-2015, 07:05 AM
RE: Knurl looseness okay? - by arvidj - 08-23-2015, 08:02 AM
RE: Knurl looseness okay? - by PixMan - 08-23-2015, 08:51 AM



Users browsing this thread: 4 Guest(s)