The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Knurl looseness okay?

Thread Modes
Knurl looseness okay?
MikeK Offline
Freshman
**
Posts: 4
Threads: 1
Joined: Oct 2013
Location: Pennsylvania, U.S.
#1
08-21-2015, 12:30 PM
I picked up some knurl dies a few years ago and am finally getting around to building a knurler for them.  They don't all have the same thickness, though.  They vary from 0.370" to 0.375".

I've never knurled before so I don't know if the wobble will be a problem.  Was thinking about grinding/lapping them all to the same thickness.

Any thoughts?
Reply
Thanks given by:


Messages In This Thread
Knurl looseness okay? - by MikeK - 08-21-2015, 12:30 PM
RE: Knurl looseness okay? - by PixMan - 08-22-2015, 11:44 AM
RE: Knurl looseness okay? - by MikeK - 08-22-2015, 12:55 PM
RE: Knurl looseness okay? - by Hawkeye - 08-23-2015, 12:06 AM
RE: Knurl looseness okay? - by RobWilson - 08-23-2015, 03:06 AM
RE: Knurl looseness okay? - by Mayhem - 08-23-2015, 06:00 AM
RE: Knurl looseness okay? - by stevec - 08-23-2015, 07:05 AM
RE: Knurl looseness okay? - by arvidj - 08-23-2015, 08:02 AM
RE: Knurl looseness okay? - by PixMan - 08-23-2015, 08:51 AM



Users browsing this thread: 3 Guest(s)