08-16-2015, 09:23 PM
with the damage to the brass inner parts of the nozzle in the burner that I use in my furnace I decided to replace all the major stuff like the Screw Pin (their name not mine)
Of which I made a couple like the one in the above photo, but it wouldn't work with the way I wanted to change the plumbing setup. So I made another one only longer.
By making it longer I was able to make more room for the air passage, plus didn't have to drill four tiny holes thru the Adapter Body to get the air where it needed to go.
In the photo of the nozzle assembled and ready to fir you can see the new Adapter Body that I made which has the oil plumbed into the back of the body and the air in the side. This configuration makes it a lot simpler for a guy in the garage to make one for his self.
its not much but its what me and the monster did today when we wasn't sitting under the AC.
Of which I made a couple like the one in the above photo, but it wouldn't work with the way I wanted to change the plumbing setup. So I made another one only longer.
By making it longer I was able to make more room for the air passage, plus didn't have to drill four tiny holes thru the Adapter Body to get the air where it needed to go.
In the photo of the nozzle assembled and ready to fir you can see the new Adapter Body that I made which has the oil plumbed into the back of the body and the air in the side. This configuration makes it a lot simpler for a guy in the garage to make one for his self.
its not much but its what me and the monster did today when we wasn't sitting under the AC.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!