08-14-2015, 10:22 AM
Russ,
That's a great example of "print to part" and well done. I appreciate how you've been able to move from one CAM software package that had no "documentation" to a fully supported one.
One question: When I look at the print in your first photo, I don't see a LOT of dimension related to the pockets, angles of bolt patterns, etc., yet the features are there on the finished part. Should I assume you actually got a package of several prints that did lay out the complete part with all features and tolerances?
That's a great example of "print to part" and well done. I appreciate how you've been able to move from one CAM software package that had no "documentation" to a fully supported one.
One question: When I look at the print in your first photo, I don't see a LOT of dimension related to the pockets, angles of bolt patterns, etc., yet the features are there on the finished part. Should I assume you actually got a package of several prints that did lay out the complete part with all features and tolerances?