MetalworkingFun Forum › Machining › Welding & Casting v
Vice rebuild

Thread Modes
Vice rebuild
ieezitin Offline
Sophmore
***
Posts: 205
Threads: 27
Joined: Jan 2013
Location: Maryland USA
#14
08-11-2015, 04:29 PM
Graphite plate stock is used to build the dam.. not cheap but can be continually used if treated with care. it can be machined as well. 

I believe if you smoke steel the braze will not adhere to it either, smoking is running an acetylene flame with no oxygen turned on over steel leaving a thick black carbon layer deposited.

Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by: f350ca


Messages In This Thread
Vice rebuild - by f350ca - 08-08-2015, 06:52 PM
RE: Vice rebuild - by Mayhem - 08-08-2015, 07:16 PM
RE: Vice rebuild - by f350ca - 08-08-2015, 08:23 PM
RE: Vice rebuild - by Pete O - 08-09-2015, 05:30 AM
RE: Vice rebuild - by ieezitin - 08-09-2015, 06:36 AM
RE: Vice rebuild - by f350ca - 08-09-2015, 08:34 AM
RE: Vice rebuild - by ieezitin - 08-09-2015, 09:10 AM
RE: Vice rebuild - by f350ca - 08-09-2015, 07:54 PM
RE: Vice rebuild - by Mayhem - 08-10-2015, 06:03 AM
RE: Vice rebuild - by Dr Stan - 08-10-2015, 07:50 AM
RE: Vice rebuild - by stevec - 08-10-2015, 06:04 PM
RE: Vice rebuild - by f350ca - 08-10-2015, 07:40 PM
RE: Vice rebuild - by Mayhem - 08-11-2015, 01:56 AM
RE: Vice rebuild - by ieezitin - 08-11-2015, 04:29 PM
RE: Vice rebuild - by mattmcp - 08-18-2015, 08:44 PM



Users browsing this thread: 2 Guest(s)